Dual Band (2 Meter & 70 cm) Solid Aluminium J-Pole

This is what I have been up to for the last week or so, building this dual band antenna out of solid aluminum, I have used 10mm solid aluminum rod, and 40mm x 40mm x 3mm angle strut for the base and the driven element connected via SO239 3/8″ stud mount.

I am very happy with the performance of the antenna and the SWR of it. and it was a hell of a lot cheaper than buying one, and more fun :-P

And if you are interested in me making one for you, head on over to my contact page and send me a message

8 thoughts on “Dual Band (2 Meter & 70 cm) Solid Aluminium J-Pole”

  1. Hi Dale. I have been absent from the hobby for 12 years. I am struggling to comprehend what’s has happened in that time. Could you send me the drawings of the “J-pole” please.

    1. Hi Jerry,

      I have never tried with iron or steel, as it would make the j-pole a lot heavier and in turn need more support when mounting on mast etc. How ever a tape and die set is rather in expensive. When cutting the threads onto aluminum remember to us something like kerosine as lubricant and to back off every couple turns to free up the die of aluminum sworf.

      Good Luck with you j-pole makings

      1. Thanks, Dale.

        Yes, I’m not worried about the weight because I would just fasten the L bracket to a piece of board to set on my attic floor. 1 lb. – 4 lbs. should make no difference. I am curious if either the material (aluminum vs. copper vs. iron/steel) or the texture (threads) would have any effect on reception or SWR, etc.

        1. Copper is the better material to make the j-pole out of, next be aluminum and the iron/steel that is zinc plated (galvanised) as zinc is a good rf conductor. The threads should not matter, I just never tried to use threaded rod that all.

Leave a Reply to Dale Cancel reply